The Stepmotor Controller board is designed to control up to 6 step motors and support CAN-FD bus, its layout and pinout are especially organised for 3D printer.
-
On board DC step down power supply to provide 5V to ODROID-M1S
-
6x step motor driver module support
-
1x CAN-FD bus support
-
1x ADC channel
-
2x GPIO inputs
-
1x MOSFET output
Specifications
| Form Factor | Board dimension : 90 (L) x 65 (W) x 16 (H) mm |
| Power input | 1x terminal block (7.62mm pitch) |
| * ODROID-M1S will be powered via this terminal. | |
| I/O | 6x Step motor connector |
| * Step motor driver module is required. | |
| 1x CAN bus | |
| 1x ADC input | |
| 1x MOSTFET output | |
| 2x GPIO input (internal pull up) |
WIKI : https://wiki.odroid.com/accessory/add-on_boards/stepperboard
